Package include:

Start up using the remote controller

The status indicator is used to indicate the power and working status of the receiver.

Transmitter LED Indicator

If the transmitter voltage is low the LED will flash slowly. This LED has six colors, greenf blue, cyan, red, yellow, white and off which can be set according to user preference.

To change the LED color follow the steps below:

Power On FS GT5 and Bind the BS6 Receiver

Follow the steps below to turn on the transmitter:

1. Make sure that:

The battery is fully charged and installed correctly.

The receiver is installed correctly and powered down.

2. Move the power switch to the [On] position.

3. Connect the power supply to the receiver.

Note • Operate with caution in order to avoid damage or injury.

Note • Make sure that the throttle is at its lowest position and the switches are set to their up position.

Binding

The transmitter and receiver have been pre-bound before delivery.

If you are using another transmitter or receiver; follow the steps below to bind the transmitter and receiver:

1. Connect the bind cable to the receiver's B/VCC port.

2. Connect power to any other port

3. Press and hold the transmitter's bind key and turn on the transmitter at the same time.

4. Once binding is complete the transmitter will exit bind mode. Remove the power and bind cable from the receiver then apply power to the B/VCC port.

5. Check to make sure everything functions as expected. If not repeat the steps above.

RF Protocol Compatible Receivers

[AFHDS 2A iA10B , iA6B , iA4B, iA10 , iA6 , iA4C , A6 , A3 , X6B , BS6 , BS4]

• This binding information only applies to the FS-GT5 and the FS-BS6 receiver; different receivers may require a different procedure to complete the binding process. Please visit the official FS website for the latest information on compatible receivers and their respective user manuals.

• All of our products receiver regular updates, please visit our website for more information and firmware downloads.

Connect the receiver and the servos as indicated below:

To ensure the gyroscope works as expected install the receiver horizontally at less that 10 degrees from level.

Calibration :

Package include:

Start up using the remote controller

To change the LED color follow the steps below:

Power On FS GT5 and Bind the BS6 Receiver

Binding

RF Protocol Compatible Receivers

Connect the receiver and the servos as indicated below:

Calibration :

MODEL:

NAME

Reverse (REV):

End Point Adjust (EPA):

Sub Trim (SUB-TR):

Dual/Rate (D/R):

Exponential (EXP):

A.B.S. (ABS):

Trim (TRIM):

Failsafe (ESAFE):

CRAWL:

S.V.C. (SVC):

Product description